Installation And Settings - Ricoh J-P3 Service Manual

20 February 2004

1.3.3 INSTALLATION AND SETTINGS

For the installation procedure, see the Operating Instructions. After you install the
printer, make the settings that are necessary for the service contract. When you
make the settings, use caution:
1. Check the contract type carefully before you do steps 2 and 3. If you make the
wrong settings, you cannot change some settings back again.
2. You must enable Meter Charge (SP5-930-001) for any meter click counter
contract. The default is "OFF" (disabled).
3. If you set Meter Charge to "ON", you must set Counter Methods (SP5-045)
(developments/prints) in accordance with the contract (☛ 5.3.1). If you change
the setting from "Prints" (default) to "Developments," you cannot change the
setting back again.
The table shows the SP Mode settings related to service contracts.
Service Program
Meter Charge > ON/OFF
(SP5-930-001)
Meter Charge > Menu (SP5-
930-003)
Meter Charge > Paper
Transfer (SP5-930-005)
Counter Method (SP5-045)
Double Count (SP5-104)
Telephone Number Setting >
Service (SP5-812-001)
Telephone Number Setting >
Fax Telephone Number
SP5-812-002
Enables or disables the Meter Charge. (Default: OFF
[Disabled])
When enabled:
• The Counter menu appears immediately after you push
the Menu key. The Counter Method (SP5-045) sets the
type of the counter.
• You can print the counter from the Counter menu.
• When the ACS mode is on, a monochrome page is
counted as such even if it follows a color page.
When disabled:
• The Counter menu is not displayed.
• The total counter starts from 0 (zero).
• When the ACS mode is on, a monochrome page is
counted as a color page if it follows a color page.
Enables or disables the PM Alert for the PCUs, development
units, and fusing unit. (Default: Click 1 [Enabled])
When the PM Alert is enabled, a message is displayed
when one of the units needs to be replaced.
Enables or disables the PM Alert for the transfer unit and
transfer cleaning unit. (Default: No Alert [Disabled])
Tells the counter when to count (each development or each
print). (Default: 1 [Prints])
Specifies whether the counter increase by +1 or by +2 when
the paper size is A3 or 11" x 17". (Default: OFF [by +1])
Shows or sets the telephone number of the service
representative.
Shows or sets the fax number of the service station. The
number is printed on the counter list when the Meter Charge is
enabled. The user can send a fax message with the counter
list.
1-7
Function
PRINTER