Ricoh J-P3 Service Manual page 110

ENGINE SERVICE MODE
1916 [Idling Mode]
1916 001 Mode Set
Executes the extra idling operation after the fusing unit becomes ready just after the
main switch has been turned on.
1916 002 Idling Time
Specifies how long the extra idling operation is executed.
1916 003 PreJob Mode
Executes the extra idling operation after the fusing unit becomes ready when a print
job arrives at the printer.
1916 004 Idling Time SP: H
Specifies how long the extra idling operation is executed when special paper is used
and the line speed is 185 mm/s.
1996 [OHP/TH Fusing] OHP/Thick Paper Fusing Temperature Correction
(Heating or Pressure Roller)
Specifies the temperature for starting a print job.
The fusing section is already warmed up when the last print job was completed. If
prints are made on OHP or thick paper at this time, the fusing temperature tends to
be higher than the target, causing exit roller marks or a paper jam in the fusing
section. To prevent this, the print job will not start if the heating and pressure roller
temperatures are higher than the following:
(Target temperature specified by SP1-105-12, -13, -23, -24) - (Temperature
specified by this SP mode (default: 5°C for heating roller, 10°C for pressure roller))
1996 004 H:Print Temp
1996 005 P: Print Temp
1996 006 PreJob Mode
This SP enables or disables the 30-second fusing unit idling at the start of an OHP
print job. When enabled, idling is done even if the machine is in the ready condition.
*BCU [0 to 1 / 0 / 1 /step]
0: Off, 1: On
*BCU [10 to 120 / 30 / 10 sec/step]
*BCU [0 to 2 / 0 / 1 /step]
0: Off
1: When a job gets to the printer
2: When a job gets to the printer and the
machine's internal temperature is less
than the temperature set with SP1-912-002
(default: 17ºC).
*BCU [0 to 360 / 0 / 1 sec/step] DFU
*BCU [0 to 20 / 0 / 1°C /step]
*BCU [0 to 20 / 0 / 1°C /step]
*BCU [0 to 1 / 0 / 1 /step]
0: Off, 1: On
5-14
20 February 2004