Ricoh J-P3 Service Manual page 134

ENGINE SERVICE MODE
5840 006
Channel Max
Sets the maximum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location. The
default settings are set for the maximum end of the range for each area. Adjust the
upper 4 bits to set the maximum number of channels. DFU
5840 007 Channel Min
Sets the minimum number of channels available for data transmission via the
wireless LAN. The number of channels available varies according to location. The
default settings are set for the minimum end of the range for each area. Adjust the
lower 4 bits to set the minimum number of channels. DFU
5840 011 WEP key number
Selects the WEP key.
5840 018 SSID Key Check
5840 020 WEP mode
Determines the operation mode of the WEP key. Displayed only when the option
801.11b for wireless LAN is installed.
5844 [USB]
5844 001 Transfer Rate
5844 002 Vendor ID
5844 003 Product ID
5844 004 Dev Release Num
5845 [Delivery Srv] Delivery Server
5845 003 Retry Interval
Specifies the retry interval.
5845 004 Number of Retries
Specifies the maximum number of retries.
5846 [UCS Setting]
5845 003 Maximum Entries
Specifies the number of maximum entries.
5845 050 Initialize All Data
Initializes all data.
5856 [Remote Update]
Allows the technician to upgrade the firmware using a parallel cable
*CTL [1 to 11 or 13 / 1 / 1 /step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting
*CTL [1 to 11 or 13 / 1 / 1 /step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting
*CTL [00~11 / 00 / 1 binary]
00: Key #1
01: Key #2 (Reserved)
10: Key #3 (Reserved)
11: Key #4 (Reserved)
Checks that the SSID is correct.
*CTL [0~1/0/1]
0: Max. 64-bit (10 characters)
1: Max. 128-bit (10, 26 characters)
*CTL Adjusts the USB transfer rate.
[0 to 1 / 0 / 1/step]
0: Auto Change, 1: Full speed
*CTL Displays the vendor ID. DFU
*CTL Displays the product ID. DFU
*CTL Displays the development release version
number. DFU
*CTL [60 to 900 / 300 / 1 second/step]
*CTL [0 to 99 / 3 / 1/step]
*CTL
*CTL
*CTL [0 to 1 / 0 / 1/step]
0: Disable, 1: Enable
5-38
20 February 2004