Ricoh J-P3 Service Manual page 141

20 February 2004
This is for the oil supply unit only, and not the fusing unit
NOTE: Use this mode as a temporary measure, only when the unit detection
mechanism is defective.
5995 [ColorGapAdj2] Color Gap Adjustment 2
Enables or disables the transfer belt feedback feature. Use this SP only as explained
in section 4.4.3.
5997 [Test Pattern]
5997 001 IntTray
5997 002 Pattern
5997 003 Color
5997 004 Mode
ENGINE SERVICE MODE
*BCU [0 or 1 / 0 / -]
0: Enabled, 1: Disabled
Selects the tray for making a test print.
[0 to 4 / 1 / 1/step]
0: By-pass Table
2: Tray 2
4: Tray 4
NOTE: The machine makes a test pattern on the
paper size loaded in the selected paper tray.
Selects a test pattern.
[0 to 23 / 0 / 1/step]
0: None
1: 1-dot sub-scan line
2: 2-dot sub-scan line
3: 1-dot main-scan line
4: 2-dot main-scan line
5: 1-dot grid pattern (fine)
6: 2-dot grid pattern (fine)
7. 1-dot grid pattern (rough)
8. 2-dot grid pattern (rough)
9. 1-dot slant grid pattern
10. 2-dot slant grid pattern
11. 1-dot pattern
12. 2-dot pattern
13. 4-dot pattern
14. 1-dot trimming pattern
15. 2-dot trimming pattern
16. Cross stitch: sub-scan
17. Cross stitch: main-scan
18. Belt pattern
19. Belt pattern (vertical)
20. Checkered Flag
21. Grey scale (vertical)
22. Grey scale (Horizontal)
23. Solid
Selects the color for making a test pattern.
[0 to 6 / 6 / 1/step] Alphanumeric
0: Red 1: Green
2: Blue 3: Yellow
4: Magenta 5: Cyan
6: Black
Selects the color mode for making a test print.
[0 or 1 / 0 / 1/step] Alphanumeric
0: Full Color 1: Single Color
5-45
1: Tray 1
3: Tray 3