Ricoh J-P3 Service Manual page 67

20 February 2004
4. Connector cover [A] (! x 1)
5. Four flat cables [B]
6. Connector [C]
7. Cover bracket [D] (! x 5)
8. BCU [E] (All "'s, ! x 8)
CAUTION: 1) When handling NVRAMs, keep them away from any objects that can
cause static electricity. The data in NVRAMs may be corrupted by
static electricity.
2) Make sure the NVRAM is correctly installed on the board. A half-disk
[F] is engraved on one side of the NVRAM, while a guide mark [G] is
on one side of the NVRAM slot. Install the NVRAM so that the half-
disk and the guide mark are on the same side.
3) When replacing the BCU, make sure that the DIP-switch settings on
the old board and on the new board are the same (☛ 5.8).
ELECTRICAL COMPONENTS
[C]
[D]
[G]
3-21
[B]
[A]
G106R919.WMF
[E]
[F]
G106R920.WMF