20 February 2004
5.1.2 REMARKS
Abbreviations and Symbols
These are the symbols and abbreviations in the service mode tables. (☛
5.2.1/5.3.1).
Paper Type
N
Normal paper
TH
Thick paper
Color Mode
[Color]
Full-color mode
[K]
Black in B&W mode
[Y]
Yellow in full-color mode
[M]
Magenta in full-color mode
[C]
Cyan in the full-color mode
[YMC]
Yellow, magenta, and cyan
[FC]
Full-color mode
[FC, K]
Black in the full-color mode
[FC, Y]
Same as [Y]
[FC, M] Same as [M]
[FC, C] Same as [C]
Paper Feed Station
P
Paper tray
B
By-pass tray
Fusing Section
H
Heating roller
P
Pressure roller
Print Mode
S
Simplex
D
Duplex
Special Setting
FA
Factory setting (The setting could
be adjusted before transportation.
See the SMC Report behind the
front cover.)
DFU
Design/Factory Use only (Do not
change the setting.)
Possible Values
The service mode tables (☛ 5.2.1/5.3.1) show the possible values as follows:
[Adjustable range / Default setting / Step] Alphanumeric
where "Alphanumeric" shows that the setting is displayed by numbers and letters.
In this type of example, the letters are not shown in the service mode tables.
SERVICE PROGRAM MODE
Line Speed
H
185 mm/s: (Not used in this
machine.)
M
162 mm/s
L
62.5 mm/s
Storage
*
The setting is stored in the NVRAM
(engine) or NVRAM (printer
controller). If you clear the RAM, the
setting returns to the default.
BCU The setting is stored in the NVRAM
on the BCU board.
CTL The setting is stored in the NVRAM
on the controller board.
Other
#
You must turn the main power
switch off and on to enable the
setting.
5-3