Controller Functions - Ricoh J-P3 Service Manual

20 February 2004

6.8.3 CONTROLLER FUNCTIONS

Paper Output Tray
You can select the default output tray with this user tool: Menu > System > Output
Tray. If the printer driver does not specify an output tray (or if the driver specifies
the default tray), the default output tray is used.
Output Tray Selected
• If the printer cannot use the selected output tray, it uses the default output tray.
• If paper overflow is detected at the selected output tray, the controller stops
printing.
Stapling
The optional two-tray finisher and booklet finisher can staple outputs. Both finishers
support the following stapling positions:
[A]: One staple (vertical) at the rear right corner
[B]: Two staples (vertical) at the right middle edge
[C]: One staple (vertical) at the front right corner
The two-tray finisher supports the following
stapling position (the booklet finisher does not):
[D]: One staple (slant) at the front right corner
The booklet finisher supports the following stapling
position (the two-tray finisher does not):
[E]: Two staples (vertical) at the center
The table lists the number of sheets that the
finishers can staple.
Two-tray finisher
Booklet finisher
NOTE:
For the paper sizes, see the specifications.
Position
[A][B][C][D]
[A][B][C]
[E]
6-25
Paper exit
Paper size
A4, B5, LT A3, Ledger, Legal
50 sheets
50 sheets
—
CONTROLLER
[A]
[B]
[C]
[D]
[E]
G106D921.WMF
30 sheets
25 sheets
10 sheets