Sp6-Xxx (Peripherals) - Ricoh B121 Service Manual

SERVICE PROGRAM MODE

SP6-XXX (Peripherals)

6006 ADF Adjustment (
NOTE: Available menus depend on the machine model and its configuration.
6006 1 ADF Adjustment (StoS/Front Regist)
Adjusts the side-to-side registration for the front side of the original, for ADF mode.
Use the  key to select "+" or "–" before entering the value
6006 2 ADF Adjustment (Leading Regist)
Adjusts the leading edge registration for ADF mode. Use the  key to select "+" or
"–" before entering the value.
6006 3 ADF Adjustment (Trailing Erase)
Adjusts the trailing edge erase margin for ADF mode. Use the  key to select "+"
or "–" before entering the value.
6006 4 ADF Adjustment (StoS/Rear Regist)
Adjusts the side-to-side registration for the rear side of duplex originals, for ADF
mode. Use the  key to select "+" or "–" before entering the value.
6006 5 ADF Adjustment (Sub-scan Magnif)
Adjust the sub-scan magnification for the ADF.
6006 6 ADF Adjustment (Original Curl Adj)
Enables or disables the skew adjustment for the reverse sides of originals. When
you enable SP6-006-6, adjust the distance of the skew adjustment (SP6-006-7).
6006 7 ADF Adjustment (Skew Correction)
Specifies the distance of the skew adjustment. SP6-006-7 is effective when you
enable SP6-006-6 (ADF Adjustment [Original Curl Adj]).
6009 ADF Free Run
6009 1 Performs an ADF free run. Press "ON" to start; press "OFF" to stop.
6010 Stamp Position Adjustment
6010 1 Adjusts the stamp position in the sub-scan direction. for the fax mode.
6901 Display ADF–APS
6901 1 Displays the status of the ADF original size sensors (
6910 ADF Shading Time
6910 1 Adjusts the interval used for the shading processing in the ADF mode. Light and
heat in the room may affect the scanner response. Reduce this setting if copy
quality indicates that the white level is drifting during ADF copy jobs.
B121 Series/B259 Series
3.13.3)
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
[–5.0 ~ +5.0 / 0.0 / 0.1 mm/step]
[–3.0 ~ +3.0 / –1.0 / 0.1 mm/step]
[–5.0 ~ +5.0 / 0.0 / 0.5 mm/step]
[–0.9 ~ +0.9 / 0.0 / 0.1 %/step]
[0 = No / 1 = Yes]
[–20 ~ +20 / 0 / 1 mm/step]
[–10 ~ +10 / 0 / 1 mm/step]
[0 ~ 60 / 10 / 1 s/step]
5-54
5.1.17).
SM