Engine Service Modes; Sp1-Xxx: (Feed) - Ricoh Gestetner LANIER SAVIN G071 Service Manual

Rev. 04/2003

5.2.2 ENGINE SERVICE MODES

The SP numbers do not appear on the screen, but they may appear on reports.
NOTE: The Service Program Mode is for use by service representatives only, so
that they can properly maintain product quality. If this mode is used by
anyone other than service representatives for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed any more.

SP1-XXX: (Feed)

Mode No.
1
(Class 1, 2, and 3)
001* Lead_Edge_Reg.
1 Tray: Plain
2 Tray: Thick
3 Tray: OHP
4 Bank1
5 Bank2
6 By-pass: Plain
7 By-pass: Thick
8 By-pass: OHP
9 Duplex
002* S-to-S_Reg.
1 By-pass
2 Tray1
3 Bank1
4 Bank2
5 Duplex
003* Paper_Buckle
1 Tray: Plain
2 Tray: Thick
3 Tray: OHP
4 Tray: SmallSize
6 By-pass: Plain
7 By-pass: Thick
8 By-pass: OHP
9 Duplex
⇒
105* Fusing_Temp.
1 H: Pre
2 H: _Ready
SM
CÓPIA NÃO CONTROLADA
Adjusts the leading edge registration by changing the
registration clutch operation timing for each mode.
[–4.0 ~ 4.0 / 0.0 / 0.1 mm/step]
• The user mode cannot adjust the settings for thick
paper or OHP sheets.
Adjusts the side-to-side registration by changing the
laser main scan start position for each mode.
[–4.0 ~ 4.0 / 0.0 / 0.1 mm/step]
Adjusts the amount of paper buckle at the registration
roller by changing the paper feed timing.
[–9 ~ 9 / 0 / 1 mm/step]
[–9 ~ 9 / –2 / 1 mm/step]
[–9 ~ 9 / –2 / 1 mm/step]
[–9 ~ 9 / –2 / 1 mm/step] (Small size: A4/LT or narrower)
[–9 ~ 9 / 0 / 1 mm/step]
[–9 ~ 9 / –2 / 1 mm/step]
[–9 ~ 9 / –2 / 1 mm/step]
[–9 ~ 9 / 0 / 1 mm/step]
Sets the temperature at which the heating roller starts
idling.
[100 ~ 180 / 140 / 1°C/step]
Sets the temperature at which the heating roller enters
the print ready condition.
[100 ~ 180 / 155 / 1°C/step]
5-11
CÓPIA NÃO CONTROLADA
SP MODE TABLES
Function / [ Setting ]
G071