Ricoh J-P3 Service Manual page 132

ENGINE SERVICE MODE
5816 [Remote Service]
Used for NRS only
5816 001 I/F Setting
5816 002 CE Call
5816 003 Function Flag
5816 004 Communication Test
Does a communication test. One of the return codes from 0 to 99 is shown:
• 0: Normal end (The service is operating.)
• 1: Normal end (The service is not operating.)
• Any other code: Abnormal end
Do the test from the User Tools. Do not use SP5-816-004 unless you are told to do
it by the manufacturer.
5816 005 Device Information
Does a device test. One of the return codes from 0 to 99 is shown:
• 0: Normal end (The service is operating.)
• 1: Normal end (The service is not operating.)
• Any other code: Abnormal end
Do the test from the User Tools. Do not use SP5-816-005 unless you are told to do
it by the manufacturer.
5816 006 Device Information
Shows or does not show the device information in the User Tools.
5816 007 SSL Disable
5816 008 RCG Connect Time
Sets the timeout counter for the remote connection.
5816 009 RCG Write Timeout
Sets the timeout counter for writing processing.
5816 010 RCG Read Timeout
Sets the timeout counter for reading processing.
5816 011 Port 80 Enable
Enables or disables access to the SOAP method via port 80.
5821 [Remote Service Address]
5821 001 CSS-PI Device Code
5821 002 RCG IP Address
Sets the IP address of the RCG (Remote Communication Gate).
5824 [NVRAMUpload] NVRAM Upload
Uploads the UP and SP mode data (except for counters and the serial number) from
the NVRAM to an SD card.
5825 [NVRAMDownload] NVRAM Download
Downloads the UP and SP mode data from an SD card to the NVRAM.
*CTL [0 to 1 / 1 / 1/step]
0: Off
1: Network (The remote service function is on.)
*CTL [0 to 1 / 1 / 1/step]
0: Start, 1: End
*CTL [0 to 1 / 1 / 1/step]
0: Off (The remote service function is disabled.)
1: On (The remote service function is enabled.)
*CTL [0 to 1 / 0 / 1/step]
0: Not displayed, 1: Displayed
*CTL [0 to 1 / 0 / 1/step]
0: Enabled, 1: Disabled
*CTL [1 to 90 / 10 / 1 second/step]
*CTL [0 to 100 / 60 / 1 second/step]
*CTL [0 to 100 / 60 / 1 second/step]
*CTL [0 to 1 / 0 / 1/step]
0: Disables, 1: Enables
*CTL [0 to 4 / 0 / 1/step] DFU
*CTL [00000000h to FFFFFFFFh / 00000000h / 1/step]
#
#
5-36
20 February 2004