Ricoh J-P3 Service Manual page 131

20 February 2004
5801 011 NCS
5801 014 DCS Setting
5801 015 Clear UCS Setting
5801 016 MIRS Setting
5802 EngineFreeRun
Performs a free run on the printer engine.
NOTE:
• The machine starts free run in the same condition as the sequence of A4/LT
printing from the 1st tray. Therefore, paper should be loaded in the 1st tray, but
paper is not fed.
• The main switch has to be turned off and on after using the free run mode for a
test.
5803 [Input Check] (☛ 5.3.3)
5804 [Output Check] (☛ 5.3.4)
5808 [Destination] Destination Code Display
Displays the destination code.
5809 [SC OFF] SC Detection ON/OFF
5809 001 ALL
Enable or disables the service call detection. The SC codes (not related to the
waste toner vibrator) are all ignored when SP5-809-001 is enabled.
5809 002 Vib Motor
Enable or disables the service call detection. The SC code related to the waste
toner vibrator is ignored when SP5-809-002 is enabled.
5810 [SC Reset]
Resets a type A service call condition. Turn the main power switch off and on after
resetting the SC code.
5811 [SN Display] Serial Number Display
Displays the machine serial number.
5812 [Tel. No. Setting]
5812 001 Service
Sets the telephone number for a service representative. This number is printed on
the Counter List, which can be printed with the user's "Counter" menu. This can be
up to 20 characters (both numbers and alphabetic characters can be input).
5812 002 FAX TEL No.
Sets the fax or telephone number for a service representative. This number is
printed on the Counter List, which can be printed with the user's "Counter" menu if
the Meter Charge mode is selected with SP5-930-1. This can be up to 13 characters
(both numbers and alphabetic characters can be input).
Initializes the system default and interface settings
(IP address also), SmartNetMonitor for
Admin, WebStatusMonitor settings, and the
TELNET settings.
Resets or deletes the DCS-related data.
Resets or deletes the UCS-related data.
Resets or deletes the MIRS-related data.
*BCU
*BCU [0 or 1 / 0 / -] Alphanumeric
0: Enable, 1: Disable
*BCU
*CTL
5-35
ENGINE SERVICE MODE