Selecting A Service Program; Changing A Setting; Quitting Sp Mode; Enabling Settings - Ricoh J-P3 Service Manual

SERVICE PROGRAM MODE

Selecting a Service Program

1. Use the up arrow key or the down arrow key to use one of these:
• 1. Service: Gets access to the Controller Service Mode
• 2. Engine: Gets access to the Engine Service Mode
• 3: End:
Goes out of the SP Mode
2. Push the enter key [E].
3. Use the up arrow key or the down arrow key to find the necessary service
program.
4. Push the enter key.
5. To go back to step 1, push the escape key one or more times.

Changing a Setting

1. Start a service program (☛Selecting a Service Program). The current setting is
shown.
2. Push the up arrow key or the down arrow key to input a value.
3. Push the enter key. The setting is changed.
NOTE: The setting does not change if you do not push the enter key.
To enable some settings, you must turn the main power switch off and on
(☛Enabling Settings).

Quitting SP Mode

1. Push the escape key one or more times until one of these is shown
• 1. Service
• 2. Engine
2. Push the up arrow key or the down arrow key until this is shown:
• 3: End
3. Push the enter key.

Enabling Settings

To enable the settings shown in this
table, you must turn the main power
switch off and on after you go out of
SP Mode.

Line Position Adjustment

If you change the settings of SP5-993-013 to 015, the new settings have an effect
on the next line position adjustment.
SP Modes Related to
the Engine
SP2-208-009
SP2-213-001
SP2-224-001 to 004
SP5-905-007
SP5-930-001 to 005
SP5-994-001 and 002
5-2
20 February 2004
SP Modes Related to
the Controller
SP5-009-001
SP5-961-001
SP5-824-001
SP5-825-001
SP5-869