Moving The Machine - Ricoh J-P3 Service Manual

PRINTER

1.3.4 MOVING THE MACHINE

!
CAUTION
Make sure that the transfer belt is in its correct position before moving the
printer, otherwise the transfer belt and the black PCU may be damaged.
NOTE: This section assumes that you manually move the machine to a different
floor in the same building. When using transportation equipment, see
section 1.3.5.
The supports on the paper feed unit or LCT make it difficult to move the machine.
You can remove them as necessary.
1. Check that the transfer belt is in the
correct position.
2. Remove the supports [A] from both
sides (! x 2 for each).
CAUTION: After moving the machine, reinstall the supports. Without them, the
machine may tip over when you draw out a paper tray or while you
work on the printer.
[A]
1-8
20 February 2004
G106I905.WMF