Panel Unit - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
8. While lifting the Upper Housing, pull out the Panel FFC from the hole of the
Upper Housing and remove the Upper Housing.
Upper Housing
Panel FFC
Figure 9-46. Removing the Upper Housing (5)
9. Remove the Panel Unit from the Upper Housing. (See
(p.311).)
Tighten the screws in the order shown in
Secure the Panel FFC and ferrite core to the Panel Shield Plate
with double-sided tape. (See
Fold the Panel FFC at the fold line, and route it along the
marking on the Panel Shield Plate.
Figure 9-47. Routing the Panel FFC
After removing/replacing the Upper Housing, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See "9.5 Adjustment"
Artisan 837/730/PX830FWD/PX730WD/TX730WD

Panel Unit

Hole of Upper Housing
"9.4.2.18 Panel Unit"
Fig. 9-44.
Fig. 9-43 (p.310).)
Marking
(p.321).)
Disassembly/assembly
9.4.2.18 Panel Unit
This section describes the disassembly/reassembly procedures of the
C H E C K
Panel Unit for Artisan 730/PX730WD/TX730WD.
P O I N T
The disassembly/reassembly procedures for Artisan 837/
PX830FWD differ from those for Artisan 730/PX730WD/
TX730WD, therefore, see
procedures.
Parts/Components need to be removed in advance:
Scanner Unit/Left Housing/Paper Guide Top Assy
Removal procedure
1. Remove the screw (x1) and release the grounding wire.
(See 9.4.2.17 Upper Housing Step1
2. Open the Panel Unit. (See Fig. 9-42
3. Release the hook (x1) on the rear of the Panel Unit, and remove the Panel
Rear Cover. (See 9.4.2.17 Upper Housing Step3
4. Peel off the Panel FFC and the ferrite core that are secured with the double-
sided tape, and disconnect the Panel FFC from the connector on the Panel
Unit. (See 9.4.2.17 Upper Housing Step4
5. Pull out the ferrite core from the Panel FFC.
(See 9.4.2.17 Upper Housing Step5
6. Remove the screws (x2) that secure the Right Hinge.
Panel Unit
Figure 9-48. Removing the Panel Unit (1)
Revision G
"9.4.2.10 Panel Unit" (p.302) for the
(p.309).)
(p.310).)
(p.310).)
(p.310).)
(p.310).)
Right Hinge
C.B.P. 3x10 (black) (6±1Kgfcm)
Confidential
311