Epson Artisan 810 Service Manual page 137

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
4. Attach the SEAL JOINT,H on the ink supply holes of the Printhead.
Ink supply holes
Figure 4-62. Assembling the Printhead (2)
5. Insert the tip of the Ink Supply Tube screwing tool to the screw holes (x2) of the
Ink Supply Tube Assy.
Ink Supply Tube Assy
Figure 4-63. Assembling the Printhead (3)
DISASSEMBLY/ASSEMBLY
SEAL JOINT,H
Ink Supply Tube screwing tool
Screw hole
Disassembly Procedures
6. Into the screw holes of the Printhead, align and slowly insert the tip of the Ink
Supply Tube screwing tool inserted in the Ink Supply Tube Assy.
If the joint of the Printhead and the Ink Supply Tube Assy is not
C H E C K
disconnected, simply tighten the screw shown in
P O I N T
using the jig.
7. Insert the thickness gauge from the hole on the side of the Ink Supply Tube
screwing tool, and remove the tool gently while holding the Ink Supply Tube
Assy.
Ink Supply Tube screwing tool
Thickness gauge
Figure 4-64. Assembling the Printhead (4)
Revision G
Fig. 4-68 without
Insert from 0 digit side
137
Confidential