Epson Artisan 810 Service Manual page 192

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Align the positioning holes (x2) of the Main Board Unit with the
dowels (x2) of the Base Frame. (See
Align the dowels (x2) of the Main Board Unit with the
positioning holes (x2) of the Holder IC Shield Plate. (See
4-185.)
Align the dowel (x1) of the Main Board Unit with the
positioning hole (x1) of the Right Cable Frame. (See
Insert the rib (x1) of the Grounding Plate M/B to the hole of the
Main Board Unit, and align the positioning hole (x1) of the
Grounding Plate M/B with the dowel (x1) of the Main Board
Unit, and attach the Grounding Plate M/B. (See
4-186.)
Figure 4-186. Attaching the Grounding Plate M/B
DISASSEMBLY/ASSEMBLY
Fig. 4-185.)
Fig.
Fig. 4-185.)
Fig. 4-185,
Hole
Rib
Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W
When attaching the CR Encoder FFC, follow the procedures
below.
1. Put the CR Encoder FFC through the ferrite core.
2. Connect the CR Encoder FFC to the connector (CN6) on
the Main Board.
3. Insert the rib of the Ferrite Core Holder B to the hole of the
Main Board, and secure it with the screw (x1).
Fig.
Align and insert the rib of
the Ferrite Core Holder B
CR Encoder FFC
For routing the FFCs, see
When replacing the Main Board, the MAC address need to be
A D J U S T M E N T
R E Q U I R E D
set if the EEPROM data could not be read from the old Main
Board. (See
Figure 4-188. Position for the MAC Address Label
After removing/replacing the Main Board, make the specified
adjustments. (See
Ferrite Core Holder B
Ferrite core
C.B.S. 3x6 (5±0.5Kgfcm)
Figure 4-187. Attaching the CR Encoder FFC
"4.4 Routing FFC/cables"
"5.2.6 MAC Address Setting"
Label, MAC address
Chapter 5 "ADJUSTMENT".)
Revision G
CN6
(p.196).
(p.217).)
192
Confidential