Panel Unit Removal - Epson PH890 Service Manual

EPSON Stylus Photo 890/1290
C H E C K
When installing SHIELD PLATE, M/B to the printer
P O I N T
mechanism, set the cables, COVER CABLE, and COVER,
CABLE; B as shown in the figure below:
COVER,
Opening
Figure 4-5. Setting the Cables to the Cable Covers
DISASSEMBLY AND ASSEMBLY
COVER, CABLE; B
Opening
Disassembly Procedures

4.2.3 Panel Unit Removal

1. Remove HOUSING. (Refer to Section 4.2.1.)
2. Remove the harness for the Panel Unit from the frame in the printer mechanism.
C H E C K
When installing the harness to the printer mechanism, be sure to
P O I N T
stick it along the marking line on the frame.
Marking Line
3. Remove 4 screws (CBS, 3x6) securing the Panel Unit together with HOUSING,
REINFORCING, RIGHT to the printer mechanism.
4. Release the hook for the for HOUSING, REINFORCING, RIGHT from the square
cutout in the printer mechanism.
Revision B
Harness
88