Scanner Open Sensor - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD

9.4.2.22 Scanner Open Sensor

This section describes the disassembly/reassembly procedures of the
C H E C K
Scanner Open Sensor for Artisan 730/PX730WD/TX730WD.
P O I N T
The disassembly/reassembly procedures for Artisan 837/
PX830FWD differ from those for Artisan 730/PX730WD/
TX730WD, therefore, see
for the procedures.
Parts/Components need to be removed in advance:
Scanner Unit/Decoration Plate Left Upper Sub/Decoration Plate Left Upper/Paper
Guide Top Assy/Upper Housing
Removal procedure
1. Release the hook (x1) and slide it in the direction of the arrow, and then
remove the Scanner Open Sensor Cover.
Upper Housing
Figure 9-59. Removing the Scanner Open Sensor Cover
Artisan 837/730/PX830FWD/PX730WD/TX730WD
"9.4.2.13 Scanner Open Sensor" (p.306)
Scanner Open Sensor Cover
Hook
Disassembly/assembly
2. Disconnect the Scanner Open Sensor cable from the connector on the Relay
Board.
3. Release the hook (x1), and remove the Scanner Open Sensor from the Upper
Housing.
Scanner Open Sensor
Upper Housing
Figure 9-60. Removing the Scanner Open Sensor
When installing the Scanner Open Sensor, route the Scanner Open
Sensor cable through the ribs (x3) of the Upper Housing as shown in
Fig. 9-61.
Figure 9-61. Routing the Scanner Open Sensor Cable
Revision G
Bottom
Relay Board
Scanner Open
Sensor cable
Hook
Scanner Open
Sensor cable
Rib
316
Confidential