Epson Artisan 810 Service Manual page 312

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
7. Remove the screws (x2) that secure the Left Hinge.
Upper Housing
Panel Unit
Figure 9-49. Removing the Panel Unit (2)
8. Lift the Panel Unit and pull out the Panel FFC from the Panel Unit, and then
remove the Panel Unit.
Panel Unit
Panel FFC
Figure 9-50. Removing the Panel Unit (3)
Artisan 837/730/PX830FWD/PX730WD/TX730WD
Left Hinge
Dowel
C.B.P. 3x10 (6±1Kgfcm) C.B.P. 3x10 (6±1Kgfcm)
Disassembly/assembly
9. Insert the tweezers or the like into section A and peel off the Panel Sheet.
Panel Unit
Reference point
for the panel
sheet attachment
Panel Sheet
Figure 9-51. Removing the Panel Unit (4)
When installing the Panel Unit, align the dowels (x2) of the
Upper Housing with the positioning holes (x2) of the Left Hinge.
(See Fig. 9-49 (p.312).)
Taking the bottom left corner of the Panel Sheet as the
reference point, align the bottom edge with the bottom rib of the
Panel Unit and put the left edge against the rib, then attach the
Panel Sheet. (See Fig. 9-51
Secure the Panel FFC and ferrite core to the Panel Shield Plate
with double-sided tape. (See
Fold the Panel FFC at the fold line, and route it through the
marking on the Panel Shield Plate. (See
Revision G
Section A
(p.312).)
Fig. 9-43 (p.310).)
Fig. 9-47 (p.311).)
312
Confidential