Epson Artisan 810 Service Manual page 167

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
2. Disconnect the Cover Open Sensor FFC from the connector of the Cover
Open Sensor, and remove the Cover Open Sensor from the Scanner Lower
Housing.
Cover Open Sensor FFC
Figure 4-126. Removing the Cover Open Sensor (2)
When attaching the Cover Open Sensor, insert it into the space
inside the ribs (x2)
in Fig. 4-127.
Figure 4-127. Attaching the Cover Open Sensor
DISASSEMBLY/ASSEMBLY
Cover Open Sensor
of the Scanner Lower Housing as shown
Cover Open Sensor
Rib
Disassembly Procedures
When routing the Cover Open Sensor FFC, route it as shown
below and in Fig. 4-122.
Artisan 810/835/PX810FW/
TX810FW/PX820FWD/TX820FWD
Put FFC through ferrite core, and
secure it with double-sided tape (x7).
Artisan 710/725/PX710W/
TX710W/PX720WD/TX720WD
Cover Open Sensor FFC
secure it with double-sided tape (x4).
Figure 4-128. Routing the Cover Open Sensor FFC
Revision G
Cover Open Sensor FFC
Double-sided tape
Rib
Put FFC through ferrite core, and
167
Confidential