Epson Artisan 810 Service Manual page 303

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
2. Lift the rib section of the Front Panel Unit Cover slightly and slide it in the
direction of the arrow to release the hooks (x8) of the Front Panel Unit Cover,
and then remove the Front Panel Unit Cover.
Figure 9-26. Removing the Panel Unit (2)
3. Disconnect the Panel FFC from the connector on the Panel Unit.
(See Fig. 9-27.)
4. Remove the Panel Unit from the Upper Housing.
Connector
Panel FFC
Figure 9-27. Removing the Panel Unit (3)
Artisan 837/730/PX830FWD/PX730WD/TX730WD
Front Panel Unit Cover
Rib section
Hook of Front Panel Unit Cover
Panel Unit
Upper Housing
When installing the Panel Unit, align the positioning hole on the
left side of the Panel Unit with the dowel of the Upper Housing.
(See
Before installing the Panel Unit, insert the Panel FFC Cover
into the hole of the Upper Housing.
After removing/replacing the Panel Unit, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See
Disassembly/assembly
Fig. 9-25.)
Panel FFC Cover
Panel Unit
Hole of Upper Housing
Figure 9-28. Installing the Panel Unit
"9.5 Adjustment" (p.321).)
Revision G
Upper Housing
303
Confidential