Rear Left Housing - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
When installing the Decoration Plate Left Upper, align the
dowels (x2) of the Upper Housing with the positioning holes (x2)
of the Decoration Plate Left Upper. (See
When installing the Decoration Plate Left Upper, route the
grounding wire of the Panel Unit through the groove of the
Upper Housing. Be careful not to let it get caught by the Upper
Housing. (See Fig.
Upper Housing
Figure 9-13. Routing the Grounding Wire
Artisan 837/730/PX830FWD/PX730WD/TX730WD
Fig. 9-12.)
9-13.)
Panel Unit
Groove
Grounding wire

9.4.2.4 Rear Left Housing

This section describes the disassembly/reassembly procedures of the
C H E C K
Rear Left Housing for Artisan 837/PX830FWD.
P O I N T
The disassembly/reassembly procedures for Artisan 730/PX730WD/
TX730WD differ from those for Artisan 837/PX830FWD, therefore,
see "9.4.2.19 Rear Left Housing" (p.313)
Parts/Components need to be removed in advance:
ADF Unit/Scanner Unit/Decoration Plate Left Upper Sub/Paper Guide Top Assy/
Upper Housing
Removal procedure
1. Remove the screws (x2) that secure the Rear Left Housing and remove the
Rear Left Housing.
Rear Left Housing Rear Left
Figure 9-14. Removing the Rear Left Housing
When installing the Rear Left Housing, insert the ribs (x2) of the
Rear Left Housing to the inside of the Left Housing. (See
Disassembly/assembly
Revision G
for the procedures.
Left Housing
Rib
C.B.A. 3x8 (6±1Kgfcm)
Fig. 9-14.)
297
Confidential