Scanner Cr Encoder Board - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
After replacing or removing the Scanner Carriage, be sure to
A D J U S T M E N T
R E Q U I R E D perform the required lubrication. (See
"MAINTENANCE".)
DISASSEMBLY/ASSEMBLY
Chapter 6
Disassembly Procedures

4.2.6.4 Scanner CR Encoder Board

Parts/Components need to be removed in advance:
ADF Unit (Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD only)/Scanner Unit/Scanner Upper Housing
Removal procedure
1. Disconnect the Scanner Motor cable from the connector on the Scanner CR
Encoder Board. (See 4.2.6.2 Scanner Motor Unit Step1
2. Disconnect the Scanner CR Encoder FFC from the connector (CN1) on the
Scanner CR Encoder Board.
3. Loosen the screw that secures the Scanner CR Encoder Board to the Scanner
Lower Housing, and remove Scanner CR Encoder Board from the Scanner
Lower Housing.
Scanner CR Encoder Board
C.B.S. 3x8 (5±1kgfcm)
Figure 4-123. Removing the Scanner CR Encoder Board
Revision G
(p161).)
CN1
Scanner CR Encoder FFC
Rib
Confidential
165