Epson Artisan 810 Service Manual page 208

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Adjustment Item
To check if the Cover open sensor operates normally.
Case open sensor check
To check the joint section for leakage when disconnecting the joint
Leak check
between the printhead and the ink tube.
Adjustment Item
Run this cleaning when dots missing is observed on an adjustment
Head cleaning
pattern printed by the adjustment program.
To minimize the amount of ink spilling when removing the
I/S decompress printhead, discharge ink in the ink tube via the Ink System (Cap)
out of the printer.
This must be carried out after replacing the Printhead in order to fill
ink inside the all nozzles of the new ASP Printhead.
Ink charge
The printer causes a maintenance error when the waste ink pad
counter reaches its maximum. Use this to reset the counter after
Consumables maintenance replacing the Waste Ink Pad. If you find the counter is close to the
counter maximum during servicing, carry out the pad replacement and the
counter reset to avoid the printer returned from the user due to the
maintenance error.
Initializes the CD-R print counter when replacing the CDR tray to
CD-R print counter clear reset the correction value for the CDR tray's deterioration applied
according to the CD-R print counter.
AID SHK error reset Resets the AID SHK error counter to confirm the cause is on either
(Artisan 810/710/PX810FW/ of AID board, the printhead or any other part when a fatal error
TX810FW/PX710W/ related to AID (AID SHK error) occurs. This cancels the fatal error
TX710W only) to specify the error part.
ADJUSTMENT
Table 5-1. Adjustment Items
Purpose
Table 5-2. Maintenance Items
Purpose
Adjustment Items and Overview
Method Outline
See "5.2.8 Case Open Sensor Check" (p.220)
how to check.
See the video manual; separately distributed, for the details.
Method Outline
Perform a head cleaning using the adjustment program, and print a
nozzle check pattern to see if all the nozzles fire ink properly.
After removing the Waste Ink Tray Assy, select "I/S Decompress"
from the menu of the adjustment program, and operate following
the instruction of the program. See "5.4.1 I/S Decompress"
After installing the Waste Ink Tray Assy, perform an ink charge
using the adjustment program, and print a nozzle check pattern to
see if all the nozzles fire ink properly. The auto cleaning is also
settable.
Replace the waste ink pads (Waste Ink Tray Assy/Lower Paper
Guide Waste Ink Pad Assy), and reset the counter to the default.
Initialize the CD-R print counter using the adjustment program.
Initialize the AID SHK error counter and troubleshoot the error
part. See "5.4.2 AID SHK Error Reset" (p.239).
Revision G
Tool
for information on • Adjustment Program
• Thickness Gauge
0.9 mm, 3.0 mm
• Leak Check jig
• Air release jig
Tool
• Adjustment Program
• Adjustment Program
(p.238).
• Adjustment Program
• Adjustment Program
• Adjustment Program
• Adjustment Program
Confidential
208