Upper Housing - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
To confirm the ADF Unit is properly secured after installing the
ADF Unit without the hook releasers attached, make sure the
hinges of the ADF Unit will not come off even if they are
unhooked from the rear of the printer. (See
Insert the terminal of the grounding wire to the end of the rib of
the Frame. (See Fig.
For routing cables, see
When installing the Cable Cover, secure it with a new Harness
Cover Clamp. (See
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD
Fig. 8-6.)
8-4.)
4.4 "Routing FFC/cables" (p196).
Fig. 8-3.)

8.3.2.2 Upper Housing

This section describes the disassembly/reassembly procedures of the
C H E C K
Upper Housing for Artisan 725/PX720WD/TX720WD.
P O I N T
The disassembly/reassembly procedures for Artisan 835/
PX820FWD/TX820FWD are the same as those for Artisan 810/
PX810FW/TX810FW, therefore, see
(p115)
Parts/Components need to be removed in advance:
Scanner Unit/Upper Left Housing/Paper Guide Top Assy
Removal procedure
The grounding wire is attached to the frame with a screw. Be
C A U T I O N
careful not to deform the Frame when removing the screw.
1. Remove the screw (x1) and release the grounding wire.
Grounding
wire
Disassembly/assembly
4.2.3.5 "Upper Housing"
for the procedures.
C.B.S. 3x6 (8±1Kgfcm)
Figure 8-7. Releasing the Grounding Wire
Revision G
266
Confidential