Adjustment; Overview - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
5. Insert the point A of the CR Porous Pad Assy to the point B of
the Ink System. After making sure that the porous pad of the
CR Porous Pad Assy touches the porous pad of the Ink System
shown in Fig. 8-24, secure the CR Porous Pad Assy and the Ink
System together to the frame with the screw.
Point B
Ink System
Figure 8-27. Installing the Ink System (4)
6. Push the switch lever in the direction of the arrow and turn the
spur gear (see Fig.
the position A (Ink System operation point) shown in
7. Visually check the cap section to make sure that the Ink System
is installed horizontally. If the cap surface is not horizontal, a
fatal error may occur due to interfering with the carriages or
print defect may occur because cleaning can not be performed
due to capping defect.
After removing/replacing the Ink System, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See

8.4 "Adjustment"

Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD
CR Porous Pad Assy
Porous Pad
Point A
8-25), then align the Transmission Arm to
(p274).)
8.4 Adjustment

8.4.1 Overview

The required adjustments after disassembling and assembling Artisan 835/725/
PX820FWD/TX820FWD/PX720WD/TX720WD are basically the same as those for
Artisan 810/710/PX810FW/TX810FWPX710W/TX710W, but some of them are
different. Check the following and make the specified adjustments.
The start-up method in the special inspection mode for Artisan
C H E C K
725/PX720WD/TX720WD differs from that for the others. See
P O I N T
8.4.3 "Special Inspection Mode" (p278)
"Touch Panel Calibration" (p279)
Check" (p279)
TX720WD in addition to the adjustments for Artisan 710/
PX710W/TX710W.
The AID inspection is not required for Artisan 835/725/
PX820FWD/TX820FWD/PX720WD/TX720WD because the
AID function is not equipped.
Fig. 8-26.
Adjustment
for the procedures.
and "Touch Panel Operation
are also necessary for Artisan 725/PX720WD/
Revision G
274
Confidential