Configuration Options; Vcu118 Board Fpga Configuration Modes - Xilinx VCU118 User Manual

On first use of the SCUI, go to the FMC > Set VADJ > Boot-up tab and click USE FMC
EEPROM Voltage. The SCUI buttons are grayed out during command execution and return
to their original appearance when ready to accept a new command. See
See the VCU118 System Controller Tutorial (XTP447) and the VCU118 Software Install and
Board Setup Tutorial (XTP449) for more information on installing and using the System
Controller utility.

Configuration Options

[Figure 2-1, callout 35]
The VCU118 board supports two of the seven UltraScale FPGA configuration modes:
• Master BPI using the onboard linear BPI flash memory
• JTAG using:
USB JTAG configuration port (Digilent module U115)
°
Xilinx platform cable 2 mm, keyed flat cable header (J3)
°
See UltraScale Architecture Configuration User Guide (UG570)
configuration modes.
Each configuration interface corresponds to one or more configuration modes and bus
widths as listed in
3, and 4, respectively. The FPGA default mode setting M[2:0] = 101, selecting the JTAG
configuration mode.
Table 3-35: VCU118 Board FPGA Configuration Modes
Configuration
Mode
Master BPI
JTAG
VCU118 Board User Guide
UG1224 (v1.0) December 15, 2016
Table 3-35. The mode switches M2, M1, and M0 are on SW16 positions 2,
SW16 DIP Switch
Bus Width
Settings (M[2:0])
010 x8, x16
101
www.xilinx.com
Chapter 3: Board Component Descriptions
[Ref 2]
CCLK Direction
Output
x1 Not applicable
Figure 3-29.
for further details on
112
Send Feedback