Installing The Vcu118 Board In A Pc Chassis; To Install The Vcu118 Board In A Pc Chassis; Atx Power Supply Adapter Cable - Xilinx VCU118 User Manual

Table 2-3: Default Jumper Settings (Cont'd)
Jumper Function
J29 BPI Flash A25 source select
Zynq-7000 AP SoC System
J110
Controller U111 QSPI_IO3

Installing the VCU118 Board in a PC Chassis

Installation of the VCU118 board inside a computer chassis is required when developing or
testing PCI Express® functionality.
When the VCU118 board is used inside a computer chassis (that is, plugged in to the PCIe®
slot), power is provided from the ATX power supply 4-pin peripheral connector through the
ATX adapter cable
cable is 2600304. See
X-Ref Target - Figure 2-3

To install the VCU118 board in a PC chassis:

1. On the VCU118 board, remove the six screws retaining the six rubber feet with their
standoffs, and the PCIe bracket. Reinstall the PCIe bracket using two of the previously
removed screws.
2. Power down the host computer and remove the power cord from the PC.
3. Open the PC chassis following the instructions provided with the PC.
4. Select a vacant PCIe expansion slot and remove the expansion cover (at the back of the
chassis) by removing the screws on the top and bottom of the cover.
VCU118 Board User Guide
UG1224 (v1.0) December 15, 2016
Default
1-2 A25 connected to FPGA U1 pin BE17
QSPI_IO3 P/U w/20K (On = P/D to
Off
GND)
(Figure 2-3) to J15 on the VCU118 board. The Xilinx part number for this
[Ref 29] for ordering information.
Figure 2-3: ATX Power Supply Adapter Cable
www.xilinx.com
Chapter 2: Board Setup and Configuration
Comments
Send Feedback
Figure 2-2 Schematic
Callout Page
7 54
8 47
X17987-100416
16