Default Switch And Jumper Settings; Switches - Xilinx VCU118 User Manual

Default Switch and Jumper Settings

Switches

Default switch settings are listed in
Table 2-2 also references the respective schematic page numbers.
Table 2-2: Default Switch Settings
Switch Function
SW1 SPST slide switch
SW12 4-pole GPIO
SW15 4-pole configuration
SW16 4-pole configuration
Notes:
1. DIP switches are active-High (connected net is pulled High when DIP switch is closed).
VCU118 Board User Guide
UG1224 (v1.0) December 15, 2016
Table 2-2. Switch locations are shown in
Default Comments
OFF Board shipped with power switch off
Positions 1-4, GPIO
0000
Positions 1-4, Zynq-7000 AP SoC System
0000
Controller U111
Position 1, System Controller Enable
0101
Positions 2-4, FPGA U1 mode M[2:0]
www.xilinx.com
Chapter 2: Board Setup and Configuration
Figure 2-1
Callout
30
26
28
35
Send Feedback
Figure 2-1.
Schematic
Page
59
55
49
3
14