Configuration Options; Jtag Configuration - Xilinx XtremeDSP Spartan-3A DSP Technical Reference Manual

Configuration options

The FPGA of the XtremeDSP Spartan-3A DSP Development Board can be configured by four major devices:
• Xilinx download cable (JTAG)
• System ACE controller (JTAG)
• Board flash memory
• SPI flash memory
The following section provides an overview of the possible ways the FPGA can be configured.

JTAG configuration

The FPGA, board's flash memory, and CPLD can all be configured through the JTAG port of the XtremeDSP
Spartan-3A DSP Development Board. The JTAG chain of the board is illustrated below.
Figure 5 XtremeDSP Spartan-3A DSP Development Board JTAG chain
The chain starts at the JTAG header (see
and goes through the System ACE controller, the board flash memory, the FPGA, the CPLD and the FMC
expansion connector. The chain bypasses the FMC expansion connector if there is no expansion module present.
JP4 jumper must not be populated for appropriate JTAG operation.
The JTAG chain can be used to program the FPGA and access the FPGA for hardware and software
troubelshooting.
The JTAG header's connection to the JTAG chain allows a host computer to transfer bitstreams to the FPGA
using iMPACT from Xilinx. The JTAG header also allows such troubleshooting tools as ChipScope Pro to
access the FPGA.
The System ACE controller can also program the FPGA through the JTAG port. By inserting a CompactFlash
card in the CompactFlash reader (see
configuration information can be stored and programmed on the FPGA. The System ACE controller supports up
to eight configuration images that can be selected using the three configuration address DIP switches (see
XtremeDSP Spartan-3A DSP Development Board parts and
System ACE controller can be instructed use any of the eight configuration images.
The configuration mode should be set to 101 (ACE_CFGADDR0_IN (OFF), ACE_CFGADDR1_IN (ON),
ACE_CFGADDR2_IN (OFF) and ACE_CFG_EN should be OFF to use System ACE configuration (see item
33, above).
XtremeDSP Spartan-3A DSP Development Board parts and
XtremeDSP Spartan-3A DSP Development Board parts and
functions). Under the control of the FPGA, the
Configuration options
functions)
functions),
31