YASKAWA CIMR-VU BA0001 Technical Manual page 87

n Programming Mode Details
The following actions are possible in the programming mode:
• Verify Function: Verify parameter setting changes from original default values.
• Setup Group: Access a list of commonly used parameters to simplify setup.
• Parameter Setting Mode: Access and edit all parameter settings.
• Auto-Tuning: Automatically calculates and sets motor parameters for Open Loop or PM Vector control to optimize the
drive for the motor characteristics.
The Setup Group within the Programming Mode
In Setup Group, the user can access the minimum group of parameters required to operate the application.
Note: Setup Group parameters are listed in
Note: Pressing ENTER from APPL navigates to the Application Preset setting display. When the set value is changed, the parameter is changed
to the optimum value for each application. It is set to 0 (General-purpose) prior to shipment.
Figure 4.5 illustrates the keys to press to enter the Setup Group.
In this example, the source of the frequency reference is changed from the control circuit terminals to the LED Operator (i.e.,
b1-01 is changed from 1 to 0).
Frequency reference
appears when powered up
<2>
Parameter Display
YASKAWA ELECTRIC SIEP C710606 18F YASKAWA AC Drive – V1000 Technical Manual
Table 4.4.
Press until
STOP
appears
STOP
LED Operator
STOP
<1> Pressing ENTER from APPL navigates to the Application
Preset setting display. When the set value is changed, the
STOP
parameter is changed to the optimum value for each
application. It is set to 0 (General-purpose) prior to shipment.
<2> Move to the right to change parameter settings. Scroll
down to view and check settings in the Setup Mode.
<3> To return to the Top Menu, press
STOP
other parameters, press
Figure 4.5 Setup Group Example
4.3 The Drive and Programming Modes
Refer to Application Selection on page
<1>
Application
Preset
Control Circuit
Terminal Select digit
to edit
<3>
Parameter Display
STOP
. To view or edit
and .
96.
4
87