YASKAWA CIMR-VU BA0001 Technical Manual page 405

No. Name
U8-08 –
U8-09 –
U8-10 –
<1> Display is in the following units: BA0001 to BA0018, 2A0001 to 2A0040, and 4A0001 to 4A0023: 0.01 A units.
2A0056 to 2A0069, 4A0031 to 4A0038: 0.1 A units.
<2> U1-03, U2-05, and U4-13 display monitor contents in amp units. When reading the value of these monitors via MEMOBUS/Modbus, a value of
8192 is equal to 100% of the drive rated output current.
<3> Parameter setting value is not reset to the default value during drive initialization, A1-03 = 1110, 2220, 3330
<4> Available in drive software versions PRG: 1011 and later. Maximum value is 65536 in drive software versions PRG: 1010 and earlier.
<5> When this value reaches 100%, the maintenance period has been reached for the component in question and the drive is at risk of faulting out due
to component failure. Periodically check the maintenance monitors to avoid this situation.
<6> Available in drive software versions PRG: 1011 and later.
<7> MEMOBUS/Modbus communications data is in 10 h units. If data in 1 h units are also required, refer to register 0099H.
<8> MEMOBUS/Modbus communications data is in 10 h units. If data in 1 h units are also required, refer to register 009BH.
YASKAWA ELECTRIC SIEP C710606 18F YASKAWA AC Drive – V1000 Technical Manual
Description
Reserved for DriveWorksEZ, Monitor 8.
Reserved for DriveWorksEZ, Monitor 9.
Reserved for DriveWorksEZ, Monitor 10.
B.2 Parameter Table
Control
Mode
Analog Output
Unit
O
Level
V/
L
f
V
0.01
– A A A
%
0.01
– A A A
%
0.01
– A A A
%
Addr.
Hex
P
M
1957
1958
1959
B
405