SRX5800 Services Gateway Hardware Guide
SRX5800 Services Gateway Cable Manager Description
Related
Documentation
SRX5800 Services Gateway Craft Interface Overview
24
The cable management system (see
card cage that has a row of fourteen dividers for securing the cables for each card. Features
in the cable management tray allow you to gently secure the cables with cable strips or
other ties. To secure the cables in place, loop the tie through the cable anchor and secure
the tie.
You can pull the cable management system up and outward to lock it into the
maintenance position. This allows you to access the lower fan tray and the air filter.
Figure 14: Cable Management System
Release handles
Replacing the SRX5800 Services Gateway Cable Manager on page 292
The craft interface shows you status and troubleshooting information at a glance and
lets you perform many system control functions (see
hot-insertable and hot-removable. The craft interface is located on the front of the
services gateway above the upper fan tray.
Figure 15: Front Panel of the Craft Interface
PEM
LEDs
PEM
0 1 2 3
OK
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
0
1
2
3
ONLINE
ONLINE
ONLINE
ONLINE
NOTE:
The craft interface draws its power from the SCBs installed in the
SCB slots 0, 1, and 2 at the center of the card cage. At least one SCB must be
installed in the services gateway for the craft interface to obtain power.
Figure 14 on page
Maintenance linkage
Routing
Yellow
Engine
Fan
alarm
LEDs
LEDs
LED
0
MASTER
1
ONLINE
FAN
OFFLINE
RE 0
RE 1
OK
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
OK
4
5
0
1
2 6
ONLINE
ONLINE
ONLINE
ONLINE
ONLINE
IOC and SPC LEDs and online/offline buttons
24) is a tray located below the
Figure 15 on page
24). It is
Alarm
Red
Alarm
relay
alarm
cutoff
contacts
LED
button
YELLOW ALARM RED ALARM
ACO/LT
NC
C
NO
NC
C
NO
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
OK
FAIL
7
8
9
10
ONLINE
ONLINE
ONLINE
ONLINE
Copyright © 2015, Juniper Networks, Inc.
OK
FAIL
11
ONLINE