Display Module - Genie S-105 Service Manual

Section 4 • Repair Procedures

Display Module

This table lists the various screens and menu options of the operating software. Some display menus are
for informational purpose only, while others can be changed to alter the machine operating parameters.
The key switch must be in the
Use the or buttons to scroll through the screens.
To change parameter values, use the
setting. Press the button to save the new value to memory. An audible beep will indicate a save to
memory.
You must exit the programming mode for the changes to take effect.
To Exit Programming Mode:
Use the scroll button
plus button once, and change
Note: If Programming mode is not exited properly, all machine programming may be lost.
Screen or Procedure
Menu
Default
Operator
With key switch
Machine
, press the
Status ON
same time.
Unit of With key switch
, press and
OFF
Measure
hold the
and
button and turn
Language
the key switch to
the
Release the
button and
press
4 - 2
position before entering the programming mode.
OFF
button (to increase) or the
to scroll through the menu until the screen displays
to , then press the enter button
NO YES
Hour meter (on power up)
Engine speed
Engine oil pressure PSI (English)
Engine oil pressure kPa (metric)
Engine temperature °F (English)
Engine temperature °C (metric)
Primary boom angle sensor
Turntable level sensor X°
Turntable level sensor Y°
Platform angle
Battery voltage
Hydraulic pressure PSI (English)
Hydraulic pressure kPa (metric)
Boom angle
and at the
Axle status
Metric/English measurements
Language selection
position.
ON
S-100 • S-105 • S-120 • S-125
Description
button (to decrease) or to select a
, then press the
EXIT
once to accept change.
Range or Selection
Engine temperature is not
displayed until engine is
above 100°F / 38°C
Use +/- buttons to change
English, German, French,
Spanish, Portuguese,
Italian, Dutch and Swedish
Part No. 102916
June 2011
REV E