Table of Contents
Advertisement
Appendix D - CLI Reference
Sw-upgrade Context Commands
294
Figure D.24 System>Sw-upgrade Level
The table below describes the commands available at the Sw-upgrade context
level of the CLI. Access the sw-upgrade context level through the System context
level. See
System Context Commands
Table D.27 Sw-upgrade Context Commands
Command
copy system sw-
upgrade
set active
set path
show active
show path
copy system sw-upgrade
Updates the system software factory image if you have both factory and upgrade
images installed on the Memory Array and you want to make the current
upgrade image the factory image.
Syntax
copy system sw-upgrade
VMA-series Memory Array Installation and Service Guide
on page 257.
Description
Updates the system software factory image if
you have both factory and upgrade images
installed on the Memory Array and you want to
make the current upgrade image the factory
image.
Sets the active partition.
Sets the path to specify where the software
upgrade files are located.
Displays which partition will boot on the next
system reboot.
Displays the path to specify where the software
upgrade files are located.
HP-AM456-9002A Rev 01
Advertisement
Table of Contents
