Chapter 3 - Installing the Array
54
Memory Gateway
The steps for connecting the Memory Array to a memory gateway are:
Orient the unconnected end of the PCIe cable(s) to align with the PCIe
1.
connector on the back of the Memory Gateway. The PCIe cable is keyed and
only goes in one way.
Securely plug the cable(s) into the PCIe connector.
2.
Power-up the Memory Array (see
3.
56). Ensure the RAID/ADMIN Status LED is solid green indicating the PCIe
ports have stabilized before continuing (approximately 1 minute).
Power-up the Memory Gateway.
4.
Verify the PCIe connection(s).
5.
Refer to the
vSHARE Memory Gateway Installation and User's Guide
information.
VMA-series Memory Array Installation and Service Guide
Powering up the Memory Array
HP-AM456-9002A Rev 01
on page
for more