Chapter 4 - Configuring the Array
Changing the Default System Settings
62
Table 4.1, Memory Array System Default
configuration default values.
When you initially log into the Memory Array through the serial interface, change
the following default configuration parameters for security and ease of use.
Table 4.2 Changing the Default System Settings
Setting
Hostname
IP address,
Gateway address,
Netmask
Password
To reset back to the factory default settings, see
Settings
on page 103.
Changing the Admin Password
Change the default password for the admin login at any time from the
context level. The admin password must:
•
Have a length between 6-12 alphanumeric characters. If six characters are
used, then mix upper/lower case letters with numbers and/or punctuation.
•
Be a combination of upper and lower case letters and numbers.
•
Not be similar to a previous password.
•
Not be a palindrome.
If you specify an unacceptable password, you will get a message that the
password is
too simple
lower case or all upper case characters. In other words, the longer the
password, the less complicated it needs to be.
To change the admin password from the default value:
Log into the Memory Array.
1.
Navigate to the
2.
context system
System
At the
context prompt, type:
3.
set admin password
VMA-series Memory Array Installation and Service Guide
Settings, on page 58 lists the system
See
Changing the
Change the network address information to your
customer location scheme to prevent problems
connecting to the Memory Array. See
Default IP Address, Netmask, and Gateway
63.
See
Changing the Admin Password
. By increasing the length of the password, you can use all
System
context level. At the root prompt, type:
Details
Hostname.
Changing the
on page 62.
Restoring the Factory Default
HP-AM456-9002A Rev 01
on page
System