Appendix D - CLI Reference
Ethernet 0 Context Commands
238
Figure D.8 Chassis>Controller>Ethernet Context Commands
The table below describes the commands available at the Ethernet 0 context
sublevel of the CLI.
Table D.9 Controller Context Commands
Command
set dhcp
set ip-address
clear ip-address
set dns-config
set dns-
nameserver
set dns-search
clear dns-
nameserver
clear dns-search
show
reset
set dhcp
Enables or disables using DHCP to automatically set the system's IP address.
VMA-series Memory Array Installation and Service Guide
Description
Enables or disables using DHCP to automatically
set the system's IP address.
Manually sets the IP address of the system.
Clears the provisioned ip/netmask/gateway to
use when DHCP is disabled.
Sets the current DNS configuration type of the
system when DHCP has been enabled.
Sets the IP address for the DNS server to use
when dns-config is set to manual.
Sets the DNS search server.
Clears the current DNS name server.
Clears the current DNS search server.
Displays information about the Ethernet port.
Resets the Ethernet port.
HP-AM456-9002A Rev 01