Table of Contents
Advertisement
Chapter 5 - Operating the System via the CLI
90
Ethernet 0
At the
3.
clear dns-nameserver
clear dns-search
To commit the changes made, at the
4.
prompt, type:
save config
Displaying the VIMM RAID Group Mapping
The Memory Array supports up to 16 RAID groups per system. Each RAID group
can contain up to five VIMMs and supports data striping across the VIMMs and
RAID groups. Four VIMMs in a RAID group contain data and one contains parity
information. Each RAID group can tolerate a single VIMM failure with no loss of
data.
To display the mapping of the RAID groups across the VIMMs:
Log into the Memory Array.
1.
Navigate to the
2.
context raid group <n>
Where:
Specifies the RAID group number.
n
RAID Group
At the
3.
show maps
The command displays information similar to the following:
raid group 2> show maps
group-number
id
state
Where:
group-
number
id
VMA-series Memory Array Installation and Service Guide
context prompt, type:
System
RAID Group
context level. At the root prompt, type:
context prompt, type:
2
76,13,44,67,69
data,data,data,data,data
Indicates the RAID group ID.
Indicates the physical VIMM ID, and matches the slot
number on the main board.
context level command
HP-AM456-9002A Rev 01
Advertisement
Table of Contents
