Table of Contents
Advertisement
HP-AM456-9002A Rev 01
Ethernet 0
At the
context prompt, type:
3.
show
If DNS is currently in automatic mode, then the status for
automatic. In the following example, the DNS name server IP address and the
DNS search domain values have been pre-provisioned.
chassis controller ethernet 0> show
dhcp
ip-address
netmask
gateway
mac-address
dns-config
dns-nameserver
dns-search
prov-dns-nameserver 10.10.0.55
prov-dns-search
For information on clearing the provisioned DNS settings see
Provisioned DNS Information
Setting the DNS Mode
To set the DNS mode on the Memory Array:
Log into the CLI via a serial connection or the Ethernet interface (see
1.
Connecting to the CLI
Navigate to the
Ethernet 0
2.
context chassis controller ethernet 0
Ethernet 0
At the
context prompt, type:
3.
set dns-config { manual | auto }
Where:
Sets the DNS mode to manual.
manual
Sets the DNS mode to automatic.
auto
You can pre-provision the IP address of the name server and the search domain
name while the DNS mode is set to automatic. See
on page 67 and
Configuring the DNS Search Domain Name
the DNS mode to manual to use the pre-provisioned values.
VMA-series Memory Array Installation and Service Guide
Configuring Domain Name System (DNS)
enabled
10.10.0.126
255.255.255.0
10.10.0.1
00:1B:97:00:00:06
automatic
10.10.0.2
violintech.net
violintech-prod.net
on page 89.
on page 59).
context level. At the root prompt, type:
dns-config
displays
Clearing
Configuring the DNS Name
on page 68. Change
69
Advertisement
Table of Contents
