Syslog Context Commands
HP-AM456-9002A Rev 01
Figure D.22 System>Logging>Syslog Context Level
The table below describes the commands available at the Syslog context sublevel
of the CLI. Access the Syslog context sublevel through the Logging context level.
See
Logging Context Commands
Table D.25 Syslog Context Commands
Command
set host
set service
show host
show service
set host
Sets the IP address of the host that will receive the system log. This host must
have syslogd configured correctly. The Memory Array sends messages to only
one syslog server at a time. See your host's syslogd documentation for
instructions. Display the man page for syslog.conf on your host for more
information.
Syntax
set host <ip_address>
VMA-series Memory Array Installation and Service Guide
on page 279.
Description
Sets the IP address for the syslogd host.
Enables or disables the service that sends the system
log.
Displays the IP address for the syslogd host.
Displays if the service that sends the system log to a
host is enabled or not.
Syslog Context Commands
287