Configuring Dhcp Settings; Displaying Dhcp Status; Enabling Dhcp - HP VMA Series Installation And Service Manual

Configuring DHCP Settings

HP-AM456-9002A Rev 01
Configure several DHCP settings and DNS information automatically or manually
on the Memory Array.

Displaying DHCP Status

Display whether or not DHCP is being used to automatically set the system's IP
address. By default DHCP is disabled.
Log into the Memory Array.
1.
Ethernet 0
Navigate to the
2.
context chassis controller ethernet 0
At the Ethernet 0 context prompt, type:
3.
show
When viewing DHCP status, information similar to the following displays:
chassis controller ethernet 0> show
dhcp
ip-address
netmask
gateway
mac-address
dns-config
dns-nameserver
dns-search

Enabling DHCP

Enable DHCP to automatically set the Memory Array's IP address.
Log into the Memory Array.
1.
Navigate to the Ethernet 0
2.
context chassis controller ethernet 0
At the Ethernet 0 context prompt, type:
3.
set dhcp enabled
To commit the changes made to DHCP, at the
4.
command prompt, type:
save config
VMA-series Memory Array Installation and Service Guide
context level. At the root prompt, type:
disabled
192.168.1.7
255.255.255.0
192.168.1.1
00:1B:97:00:00:05
manual
undefined
undefined
context level. At the root prompt, type:
Configuring DHCP Settings
System
context level
65