Table of Contents
Advertisement
Chapter 6 - Servicing the Array
110
Where:
Specifies the VIMM slot ID. Valid values are in the range of 0-
n
83, inclusive.
At the context prompt, type:
3.
show led-state
The command displays information similar to the following:.
chassis board 0 slot 12> show led-state
led-state
Testing the VIMM LEDs
Test the LEDs associated with a specific VIMM. The slot ID is specified when you
navigate to the Slot context level. The LEDs stay lit for two seconds, blink fast for
two seconds, blink slowly for two seconds, then return to the previous state.
To test the VIMM LEDs:
Log into the Memory Array.
1.
Navigate to the
2.
context chassis board 0 slot <n>
Where:
Specifies the VIMM slot ID. Valid values are in the range of 0-83.
n
At the context prompt, type:
3.
set led-test start
VMA-series Memory Array Installation and Service Guide
slow-flash
Slot
context level. At the root prompt, type:
HP-AM456-9002A Rev 01
Advertisement
Table of Contents
