Table of Contents
Advertisement
Chapter 4 - Configuring the Array
66
Disabling DHCP
Disable DHCP to manually set the Memory Array's IP address. This is the system
default setting.
Log into the Memory Array.
1.
Navigate to the
2.
context chassis controller ethernet 0
At the
Ethernet 0
3.
set dhcp disabled
To commit the changes made to DHCP, at the
4.
command prompt, type:
save config
If DHCP is disabled, you must manually configure the system's IP address. See
Changing the Default IP Address, Netmask, and Gateway
Once you have manually configured the IP address while DHCP is disabled, you
will see that the manually provisioned IP addresses takes effect.
chassis controller ethernet 0> show
dhcp
ip-address
netmask
gateway
mac-address
dns-config
dns-nameserver
dns-search
VMA-series Memory Array Installation and Service Guide
Ethernet 0
context level. At the root prompt, type:
context prompt, type:
disabled
10.10.0.125
255.255.255.0
10.10.0.1
00:1B:97:00:00:05
manual
undefined
undefined
System
context level
on page 63.
HP-AM456-9002A Rev 01
Advertisement
Table of Contents
