System Leds; Figure 1.2 Memory Array - Rear View - HP VMA Series Installation And Service Manual

HP-AM456-9002A Rev 01
The power button on the front of the array can be used to cause the array to
shutdown mode similar to executing the shutdown CLI command.
enter into a
With a shutdown the media is taken offline and I/O stopped to the connected
hosts, but the array is left powered on and able to be managed via the CLI. Use
the reboot CLI command to bring the array media back online and allow I/O to
the connected hosts.
To shut down the system from the front panel, depress the power button for 4
seconds. If the LCD does not indicate the system is shutting down after 10
seconds, depress the power button for another 4 seconds. The LCD should
display that the system is shutdown and it is safe to remove the power cords if
desired.
The array is not actually powered off when using the power button.
Note:
Instead the array is logically shut down and the data paths are disabled, placing
the array in a safe mode for removing power cords.
Before turning off power to the Memory Array, shut down any direct-attached
hosts.
Rear View
The rear panel provides the interfaces for connecting input and output devices,
and power supplies. Each interface on the rear of the system has an associated
LED and indicates if the interface is in use or not.
Console

Figure 1.2 Memory Array - Rear View

System LEDs

Eight system LEDs are located on the front of the Memory Array and four system
LEDs are on the rear.
VMA-series Memory Array Installation and Service Guide
Ethernet Rear
Port LEDs
A RAID
B ADMIN
LOC
Serial Power
Supply A
Physical Components
PCIe
Port 2
Power GND
Supply B
25