Appendix D - CLI Reference
296
The command displays information similar to the following:
system sw-upgrade> show active
Checking partition information ...
The active partition is set to 'factory'
Where:
upgrade
factory
show path
Displays the current setting for the location of the upgrade software.
Syntax
show path
The command displays information similar to the following:
system sw-upgrade> show path
Upgrade image path = 'admin@ftp://linux_host_06/upgrade.img'
VMA-series Memory Array Installation and Service Guide
Specifies that the upgrade partition in flash is set to be
activated during the next system reboot. The upgrade
partition contains the downloaded upgrade software.
Specifies that the factory partition in flash is set to be
activated upon the next system reboot. The factory
partition contains the factory configuration defaults.
HP-AM456-9002A Rev 01