Alarms Context Commands
HP-AM456-9002A Rev 01
Figure D.16 System>Alarms Context Level
The table below describes the commands available at the Alarms context
sublevel of the CLI. Access the Alarms context sublevel through the System
context level. See
System Context Commands
Table D.18 Alarms Context Commands
Command
Displays the current alarms on the system.
show
show
Displays the current alarms on a Memory Array. The following are possible
alarms:
•
Lid has been removed
•
Fan tray has been removed
•
Fan is not operating at its correct speed
•
VIMM is experiencing low voltage
•
VIMM is over the maximum allowable temperature
Syntax
show
Example
To display the current alarms on a system, at the Alarms context prompt, type:
show
VMA-series Memory Array Installation and Service Guide
Alarms Context Commands
on page 257.
Description
273