Table of Contents
Advertisement
Chapter 5 - Operating the System via the CLI
84
slot
state
protocol
link-width
neg-link-width
max-data-rate
cfg-data-rate
host
slot
state
host
If the VIMM configuration is invalid, or the system is rebuilding the RAID groups,
then up to two extra lines are displayed that list:
•
ID numbers of the affected VIMMs
•
When the RAID group rebuild is active
•
Affected RAID group and VIMM
Displaying the System Operational Time
Display how long a system has been operational since the last time it was
rebooted (i.e., uptime). The time is displayed in tenths of a second and in year, day,
HH:MM:SS
format.
To display how long the system has been operational:
Log into the Memory Array.
1.
Navigate to the
2.
context system
System
At the
context prompt, type:
3.
show uptime
The command displays information similar to the following:.
system> show uptime
tenths-second
time
Where:
tenths-second
VMA-series Memory Array Installation and Service Guide
port-2
enabled
pcie
4
4
10 Gb/s
10 Gb/s
detected
port-0
disabled
undetected
System
context level. At the root prompt, type:
132712724
0 years, 153 days, 14:27:52
Displays how long, in tenths of a second, the system
has been operational since the last power cycle or
system reboot.
HP-AM456-9002A Rev 01
Advertisement
Table of Contents
