Table of Contents
Advertisement
Chapter 4 - Configuring the Array
Formatting the Memory Array
74
The array is formatted to 65% usable capacity at the factory and can
Note:
be used without change.
To change the format of the Memory Array:
Log into the Memory Array.
1.
At the root CLI prompt, type:
2.
format flash-capacity [<value>]
Where:
Specifies the percentage of usable flash capacity. Valid values
value
are:
• 50
• 65
• 78
• 84
• 87
• 90 — Not recommended for high performance or high reliability
systems.
Default is 65%.
Higher usable percentages provide more usable capacity where needed. Lower
usable percentages increase system write performance, endurance, and
reliability. For advice on selecting a good usable percentage, consult with HP
Customer Support.
VMA-series Memory Array Installation and Service Guide
HP-AM456-9002A Rev 01
Advertisement
Table of Contents
