Ethernet Evc - Cisco ME 3400 Command Reference Manual

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

ethernet evc

Use the ethernet evc global configuration command to define an Ethernet virtual connection (EVC) and
to enter EVC configuration mode. Use the no form of this command to delete the EVC.
This command is available only if your switch is running the metro IP access or metro access image.
Syntax Description evc-id
Defaults No EVCs are defined.
Command Modes
Global configuration
Command History Release
12.2(25)SEG
Usage Guidelines After you enter the ethernet evc evc-id command, the switch enters EVC configuration mode, and these
configuration commands are available:
•
•
•
•
•
Examples This example shows how to define an EVC and to enter EVC configuration mode:
Switch(config)# ethernet evc test1
Switch(config-evc)#
Related Commands Command
service instance
evc-id
show ethernet service evc
OL-9640-10
ethernet evc evc-id
no ethernet evc evc-id
The EVC identifier. This can be a string of from 1 to 100 characters.
Modification
This command was introduced.
default: sets the EVC to its default states.
exit: exits EVC configuration mode and returns to global configuration mode.
no: negates a command or returns a command to its default setting.
oam protocol cfm svlan: configures the Ethernet operation, administration, and maintenance
(OAM) protocol as IEEE 802.1ag Connectivity Fault Management (CFM) and sets parameters. See
the oam protocol cfm svlan
uni count: configures a UNI count for the EVC. See the
id ethernet
command.
Description
Configures an Ethernet service instance and attaches an EVC to it.
Displays information about configured EVCs.
Cisco ME 3400 Ethernet Access Switch Command Reference
uni count command.
ethernet evc
2-113